Traxxas Jato 3.3 1/10 Scale Nitro Steel CV Driveshaft Set

Ditch the twisting plastic sliders and put that TRX 3.3 nitro power straight to the dirt where it belongs.

If you're tired of snapping stock half-shafts after a heavy landing or want to shave off crucial rotational mass for quicker holeshots, the Traxxas 5551X Steel CV Driveshaft Set is the ultimate drivetrain upgrade for your Jato. Engineered specifically for the extreme suspension articulation of the Jato platform, these premium metal shafts offer less than 1mm of total dogbone plunge throughout the entire suspension stroke. This means you get buttery-smooth power delivery without ever having to artificially limit your shock travel.

Unlike cheap aftermarket knock-offs that rely on grub screws that back out mid-race, the Traxxas U-joint pins are held fully captive by the carrier ball bearings. To top it off, the outer CV joints are factory-lubricated and sealed tight behind durable rubber boots, keeping out the abrasive track dust and nitro grime that ruins standard exposed joints.

Why You'll Love It

• Quicker Acceleration: By centralizing mass, these shafts significantly reduce overall rotational inertia compared to bulky stock plastic shafts, letting your engine spool up faster.
• Captive Pin Design: The U-joint pins are trapped securely by the inner race of the wheel bearings. No threadlocker needed, and zero chance of throwing a pin on a speed run.
• Sealed Outer Joints: Factory-lubricated outer joints are protected by thick rubber boots, locking grease in and keeping destructive grit out for a much longer lifespan.
• Zero Travel Limitation: Custom computer-aided design allows extreme articulation angles without binding or limiting the Jato's massive suspension travel.

What's Under the Hood

• Drivetrain Application: Rear 2WD Driveshafts
• Joint Style: Constant Velocity (CV) with sealed outer boots
• Material: High-strength hardened steel
• Design: Centralized mass layout for reduced rotational inertia

Specifications

• Length: 150mm (Approx 5.9")
• Material: Steel shafts with rubber boots
• Plunge: Less than 1mm over full travel
• Compatibility: Direct fit for Traxxas Jato 2.5 and Jato 3.3

What's In The Box

• (2) Assembled Steel CV Driveshafts with Protective Boots

Note: Replaces the stock plastic half-shafts (TRA5550). Pro-Tip: Check your wheel bearings when installing these. Since the driveshaft pin rides directly against the bearing race, a seized or gritty bearing can prematurely wear out the shaft hub. If they feel crunchy, swap them out before assembly!